LG 65WT980H - Tools You will Need

6
ENGLISH_Index
Provided item
Wall mount Punching Guide
Wall mounting screw
Ø 5 x L65
Wall mounting anchor
Wall mounting screw for wood
Ø 3 x L18
• Check the material of the wall and the thickness of the finishing.
• Use the Wall mount anchor for wall material of concrete, light
concrete, strong natural stone, soft natural stone masonry brick and
hallow block that do not crack.
Wall material Tools Wall width
Concrete
Wall mounting
anchor, Wall
mounting screw,
Ø3/6/8mm
Drill bit
70mm
Brick
Natural stone
Metal Panel
Plywood
Wall mounting
screw, Ø1.8mm
Drill bit
30mm
EPS Panel Penetrate the wall
Plasterboard +
Plywood
30mm
• When installing on a gypsum board or medium-density fiberboard
(MDF) wall, fasten the screws to the wooden pillars that support the
wall. If there are no wooden pillars, check the distance from the inner
wall before installing.
- 30mm or below: Install directly on the inner wall using a 65mm
screw.
- 30mm or above: Install using a separate hanger.
Wall
• When installing the wall mount, check the positions of the wooden
studs using a stud finder. Then, fasten the screws on at least two
separate studs before proceeding.
Stud
Wall mount
• When installing the product on wall material not designated, install
the product so that each location can withstand the pull out load of
70kgf (686N) and shear load of 100kgf (980N) or above.
• Use the Ø8mm drill bit for concrete and hammer (Impact) drill.
Tools you will need
• Phillips head + driver (manual or motorized), Ø3/6/8mm Drill bit,
Level, Stud finder, Drill