LG 65WT980H - How to Attach to Masonry Walls

7
ENGLISH_Index
How to attach to masonry walls
Please follow the below direction.
1 Use a drill bit Ø8mm to drill a hole for the anchor location within a
depth of 80mm to 100mm.
2 Clean the drilled hole.
3 Insert the sealed wall mounting anchor to the hole. (When inserting
the anchor, use a hammer.)
Wall mounting anchor
4 Set the wall mount on the wall by aligning to the location of the
hole. And, set the angle adjusting part to face upward.
Wall mount
5 Align the wall mounting screw to the hole and tighten it. Then,
fasten the screws at torque of 45kgf/cm to 60kgf/cm.
Wall mounting screw
• When mounting a TV on the wall, make sure not to install
the TV with the power and signal cables hanging from the
back of the TV.
• Do not install this product on a wall if it could be exposed
to oil or oil mist. This may damage the product and cause
it to fall.
• Make sure that children do not climb on or hang on the TV.
• Use a platform or cabinet that is strong and large enough to
support the TV securely.
• When installing the product, rst check that the wall is
strong enough. Use the anchors and screws provided.
- If you use anchors and screws that are not specified by
the manufacturer, they may not hold the weight of the
product, causing safety issues.
• Be sure to use the accessory cable provided. Otherwise,
friction between the product and the wall may cause
damage to the connector.
• When drilling holes into the wall, make sure you use a drill
and drill bit with the specied diameter. Ensure that you also
follow the instructions regarding the depth of the holes.
- Otherwise, the product may be installed incorrectly and
cause safety issues.
• Wear safety gloves when installing the product. Do not use
your bare hands.
- Otherwise, it may cause personal injury.
• If some parts of the wall mount do not touch the wall after
it is attached, use the double-sided tape included in the
accessory box to stick the mount to the wall.
• If some parts of the wall mount do not touch the wall after
using the wall mounting screws for wood, use the remaining
screws.
• Be sure to use only the exclusive wall mounting screws
provided as accessories.
• If you want to connect the TV Cable is connected to the back
panel partition, please use the enclosed Punching Guide.