LG 65WU960H - Page 20

20
206-4335
Basic Settings Wizard (Cont.)
(Continued from previous page)
Congure a Wireless (Wi-Fi) Network Connection
BACK
NETWORK SETTINGS
Configure network settings.
Network Connection Type
Wireless (Wi-Fi)
Wireless (Wi-Fi) Network
Network A
X
^
^
Advanced Options
Automatically Assign IP Address
IP Address
10.1.2.4
02
NEXT
a. Select/highlight the Network Connection Type eld, and press the Wheel (OK) button on the
Installer Remote. Then, use the Up/Down arrow keys to select/highlight Wireless (Wi-Fi),
and press the Wheel (OK) button once more.
b. Select/highlight the Wireless (Wi-Fi) Network eld, and press the Wheel (OK) button on the
Installer Remote. Then, use the Up/Down arrow keys to select/highlight the desired access
point from the drop-down list of available options, or select the “Hidden Network” option at the
bottom of the list to specify an access point with a hidden SSID. Press the Wheel (OK) button
once more.
Note: Make sure you have the network security password/PIN available if you are attempting
to connect to a secured network. If you would like to add an access point with a hidden SSID,
you will need to direct enter the SSID of the access point.
c. Follow the on-screen instructions to complete the appropriate network conguration. Use the
Installer Remote to navigate between elds and make entries, etc.
Note: As with a wired connection, you will have the option to specify static IP conguration
data for this network connection. Once the initial connection is established, you can de-select
the “Automatically Assign IP Address” checkbox under “Advanced Options,” and then modify
the IP data, as required. See step (d) of the wired connection procedure above for further
information on the data entry elds.
d. Once the wireless network conguration is complete, use the arrow keys on the Installer
Remote to select CONNECT, and then press the Wheel (OK) button on the Installer Remote.
Note: The “CONNECT” button becomes a “NEXT” button once the connection is successful.
3. In the Portal Settings screen, you can specify the Portal Mode and the Portal Auto Start status
for this TV. Use the arrow keys on the Installer Remote to select/highlight each appropriate eld
in turn—Portal Mode or Portal Auto Start—and then press the Wheel (OK) button. Then, use
the up/down arrow keys to select the applicable value from the drop-down list of options for the
selected eld.
(Continued on next page)