56
206-4335
Cloning Procedures (Cont.)
(Continued from previous page)
• If the wizard is displayed, you can complete the import procedure via the EZ-Manager Wizard,
as indicated above (see “Before You Begin”). However, to continue with this procedure and
access the “Import Clone File” option from the TV menus, exit the First Use Wizard. Then,
continue with step 3.
• If the wizard is not displayed, go directly to step 3.
3. If applicable (see also “Before You Begin” above), make sure to set the appropriate TV Zone #
and/or Wi-Fi Zone # in the Target TV at this time.
Note: In order for the proper TV Zone and/or Wi-Fi Zone prole data to be applied,
the appropriate TV Zone # and/or Wi-Fi Zone # must be set in the Target TV BEFORE
importing is initiated.
4. Insert the USB memory device with the Clone/Conguration (.tlx) le into either of the USB
ports on the Target TV.
5. Press the button on the Installer Remote to display the TV setup menus (TV is in Pass-
through Mode) or the Function Menu (TV is already in FTG Mode).
6. (TV in Pass-through Mode only) From the Quick Settings Menu displayed at the right of the
screen, select the All Settings menu icon and press the Wheel (OK) button to access the
advanced TV setup menus.
7. Use the arrow navigation keys to select/highlight either the General menu icon from the TV
setup menus or the Safety menu icon from the Function Menu. Then, press the number “7” key
a total of seven times to access the TV Manager.
Note: Ez Download is always selected by default when you initially access the TV Manager.
Also note that Diagnostics is for service use only.
X
USB DEVICE
TV MANAGER
USB 1:
Device Name
Select the desired option below.
DIAGNOSTICS: ON
Ez Download Data Cloning Image Download Icon Download Software Update
(Continued on next page)
To Next Page
Loading...
