LG 65WU960H - Page 76

76
206-4335
IP Environment Setup (Cont.)
(Continued from previous page)
• When you have entered all the beacon identication data, select the the Wheel (OK) button
button at the bottom of the menu, and then press the Wheel (OK) button on the Installer
Remote.
• At the prompt for broadcast conrmation, select either Yes to broadcast the Beacon or No if
you do not want to broadcast the Beacon.
5. If desired, you can specify a name for this TV so that it is easy to identify and differentiate from
other TVs for which sharing has been/will be enabled.
Note: By default, the TV name is the TV’s serial number. However, if a room number is specied
in the EZ-Manager Wizard or in the General Menu / Room Info screen, the TV name is changed
to the room number.
To edit the TV name, use the Up/Down arrow keys to select the TV Name eld, and then press
the Wheel (OK) button. You can then use the number keys on the Installer Remote to direct
enter a numeric TV name, or you can use the arrow keys to select the appropriate alphanumeric
character(s) from the pop-up virtual keyboard at the bottom of the screen. When you are done,
select Enter from the virtual keyboard, and then press the Wheel (OK) button on the Installer
Remote.
6. Once all elds are completed as required, use the arrow keys on the Installer Remote to return to
the IP Environment Menu, as necessary, or press BACK/EXIT to exit the IP Environment Menu.
Note: While Smart Share, Screen Share, Media Renderer, and DIAL settings are clonable, SoftAP
and Beacon settings, as well as the TV name cannot be cloned.