13INSTALLATION
ENGLISH
5 Drill a hole in the wall and insert the drywall
anchor b if needed.
• Before drilling, make sure that there are no
pipes or electrical wires inside the wall at
the desired location.
• For drywall anchor: use 1/4″ (6.5 mm) drill
bit
• For concrete or wall stud: use 1/8″ (3 mm)
drill bit
• If screwing into drywall, use the drywall
anchor.
6 Align the wall anchoring block c of the
charging station, and fix the charging station
to the wall by tightening the anchoring screw
d all the way.
7 Plug the power cord into the power outlet.
Using Double-Sided Tape to Secure the
Appliance
1 Use the double-sided tape a to attach the
wall anchoring block b to the charging
station.
• Remove the center section of double-sided
tape before attaching it to the wall
anchoring block.
2 Attach the second piece of double-sided tape
to the other side of the wall anchoring block
to secure it to the wall.
• Do not use double-sided tape on wallpaper.
Wall-Mounted Installation
For wall-mounted installations, the charging
station must be attached securely to the wall using
the provided (short) wall anchoring screws.
• The detachable nozzle storage cannot be
attached to the charging station in a wall-
mounted installation.
• Do not use double-sided tape to attach the
charging station to wallpaper. The weight of the
charging station and the product body could
damage the paper.
• Use the stand anchoring screw on concrete or
solid walls. If the appliance is not anchored
securely and falls, it could result in damage to
property or the product.
1 Connect the power adapter to the port on the
back of the charging station.
2 Drill 2 holes and insert the drywall anchors (if
needed) at least 3.25 ft (1 m) from the floor
and near enough to easily reach a power
outlet.
• Before drilling, make sure that there are no
pipes or electrical wires inside the wall at
the desired location.
To Next Page
Loading...
