To Next PageTo Next PageWhat causes high suction pressure and high temperature in LG AP-Z?
If your LG Air Conditioner has a higher suction pressure and a high temperature, it might be due to a defective compressor or a defective 4-way reverse valve. In both cases, the current will be low.
What happens when all refrigerant leaks from LG Air Conditioner?
If all the refrigerant has leaked out of your LG Air Conditioner, the current will be less than 80% of the rated current.
What does it mean if the temperature difference is over 8°C in my LG AP-Z Air Conditioner?
Normal.
Why does my LG AP-Z have higher suction pressure and normal temperature?
If your LG Air Conditioner shows higher suction pressure but a normal temperature, this could be due to an excessive amount of refrigerant. In this case, the high pressure may not rise quickly at the start of operation.
Why does my LG Air Conditioner have higher suction pressure and high temperature?
If your LG Air Conditioner is showing higher suction pressure along with a high temperature, it could be caused by a defective compressor or a defective 4-way reverse valve. In both cases, the current will likely be low.
General| Brand | LG |
|---|---|
| Model | AP-Z Series |
| Category | Air Conditioner |
| Language | English |
Safety guidelines for unit installation.
Safety guidelines for operating the unit.
Wiring diagrams for AP-Z286RC0, R20, R30 models.
Wiring diagram for AP-Z728FA0 model.
Wiring diagram for AP-Z488TCO model.
Details unit operation in heating mode.
Guidelines for selecting the best location for the indoor unit.
Guidelines for selecting the best location for the outdoor unit.
Specifications for piping length and elevation limits.
Steps for installing the indoor unit.
Steps for installing the outdoor unit.
Guidelines for refrigerant charge based on piping length.
Step-by-step guide for installation procedures.
Lists necessary tools and parts for installation.
Steps for cutting pipes, removing burrs, and flaring.
Steps for connecting pipes and tubing.
Guidelines for bending tubing to avoid cracks.
Important considerations before and during test run.
