ENGLISH
15
OPERATING INSTRUCTIONS
Dehumidification Mode
In rainy season or high humidity climate, it is
possible to operate simultaneously dehumidi-
fier and cooling mode to remove humidity ef-
fectively.
1 Press | button to turn on the indoor.
2 Press c button to select dehumidification
mode
- Room temperature will be displayed after
desired temperature is indicated at dis-
play section for about 5 seconds.
Power Cooling/Heating Mode
Strong cooling/heating will be conducted in
short time.
1 Press | button to turn on the indoor.
2 Press button to operate power cool-
ing/heating mode.
- When power (cooling/heating) button is
pressed during cooling/dehumidification
mode, power cooling will be operated.
In power cooling mode, desired tempera-
ture is set to 18 °C and the horizontal lou-
ver is fixed at the highest position.
- When power (cooling/heating) button is
pressed during heating operation, power
heating will be operated.
In power heating mode, desired tempera-
ture is set to 30 °C and the horizontal lou-
ver is fixed at the lowest position.
Fan Mode
1 Press | button to turn on the indoor unit.
2 Press button to circulate indoor air.
- When canceling operation, press
button once more.
- During fan mode, outdoor fan and com-
pressor will not be operated.
- During fan mode, indoor unit turns on the
fan mode lamp, room temperature lamp,
and fan speed lamp of its display panel.
1 Press | button to turn on the indoor unit.
2 Press button on remote controller to
circulate indoor air.
- When canceling operation, press
button once more.
- During fan mode, outdoor fan and
compressor will not be operated.
- During fan mode, indoor unit turns on the
fan speed lamp and room temperature
lamp of its display panel.
Simple Reservation
This function is able to turn on unit after a set-
ting time.
1 When the unit is turned off, adjust desired
setting time with button.
- Up to the maximum of 24 hours can be
selected.
This function is able to turn off unit after a set-
ting time.
1 When the unit is turned on, adjust desired
setting time with button.
- Up to the maximum of 7 hours can be se-
lected.
Turning OFF reservation mode
Turning ON reservation mode
NOTE
!
After performing the setting, if corresponded
setting button is pressed once, remaining set-
ting time will be displayed, and if it is pressed
once again, corresponded setting function will
be cancelled. (same function as ) Remaining
setting time will be displayed with the unit of 1
hour.
Cooling only
Cooling only
Heat Pump
1,MFL67724511,영어 2017. 7. 6. 오후 5:33 페이지 15
To Next Page
Loading...
