The controls will look like the following.
ON/OFF BUTTON
Used to turn off/on the unit.
OPERATION MODE SELECTION BUTTON
Used to select the operation mode.
ROOM TEMPERATURE SETTING BUTTONS
Used to select the room temperature.
INDOOR FAN SPEED SELECTION BUTTON
Used to select fan speed in six steps low, medium-low,
medium, medium-high, high and natural wind.
HORIZONTAL VANE CONTROL BUTTON
Used to set the desired vertical airflow direction.
VERTICAL LOUVER CONTROL BUTTON(Optional)
Used to set the desired horizontal airflow direction.
AUTO CLEAN BUTTON
Used to set auto clean.
C TO F SWITCHING BUTTON
Used to switch temperature reading from
Centigrade to Fahrenheit.
ROOM TEMPERATURE CHECKING BUTTON
Used to check the room temperature.
TIMER BUTTON(before adjusting)
Used to set the current time and the time of starting / stopping.
TIME ADJUSTING BUTTONS
Used to adjust the time.
TIMER SET/CLEAR BUTTON(after adjusting)
Used to set and to cancel the timer operation.
RESET BUTTON
Used prior to resetting time.
PLASMA BUTTON(Optional)
Used to start or stop the plasma-purification.
LED LUMINOSITY BUTTON(Optional)
Used to adjust LED luminosity.
Cooling Operation
Auto Operation or Auto Changeover
Healthy Dehumidification Operation
Heating Operation (Only heat pump)
Air Circulation
Signal transmitter
Operation Mode
(Optional1)
(Optional2)
(Optional3)
To Next Page
Loading...
Need help?
General
