Operating20
Operating
2
Listening to the radio
1. Press FUNCTION on the remote control until
FM appears in the display window.
The last received station is tuned in.
2. Auto tuning : Press and hold TUNING-/+ for
about 2 seconds until the frequency indication
starts changing, then release. Scanning stops
when the unit tunes in a station.
Manual tuning : Press TUNING-/+ repeatedly.
3. Adjust the volume by pressing VOL+/-.
Improving poor FM reception
Press
T
on the remote control. This will change
the tuner from stereo to mono. Then the reception
will be better than before.
Presetting the Radio Stations
You can preset 50 stations for FM. Before tuning,
make sure to turn down the volume.
1. Press FUNCTION until FM appears in the display
window.
2. Select the desired frequency by pressing
TUNING-/+.
3. Press PROGRAM/MEMORY. A preset number
will blink in the display window.
4. Press PRESET/FOLDER
W
/
S
to select the
preset number you want.
5. Press PROGRAM/MEMORY. The station is
stored.
6. Repeat steps 2 to 5 to store other stations.
7. To listen a preset station, press
PRESET/FOLDER
W
/
S
.
Deleting all the saved stations
1. Press and hold PROGRAM/MEMORY for two
seconds. “ERASEALL” will blink on the display
window.
2. Press PROGRAM/MEMORY to erase all saved
radio stations.
CM2330-DG.DDEULLK_ENG_6461.indd 20 2013-08-28 9:32:33
To Next Page
