To Next Page

To Previous Page

- 49 -

Only for training and service purposes

LGE Internal Use Only

6.11 Two Thermistor Control

Function Code Thermistor setting

Set Thermistor value by pressing button. (01: Remote Controller,

02: Indoor, 03: 2TH)

Press button to save.

If moving to room temperature perception sensor selection menu by

pressing button, it indicates as picture below.

If pressing button long for 3 seconds, it enters into

remote controller setter setup mode.

- If pressing once shortly, it enters into user setup mode.

Please press more than 3 seconds for sure.

Pressing button will exit settings mode.

❈ After setup, it automatically gets out of setup mode if there is no button input

for 25 seconds.

❈ When exiting without pressing set button, the manipulated value is not

reflected.

h The function of 2TH has different operation characteristics according to the product.

This is the function to select the temperature sensor to judge the room temperature.

Temperature sensor selection Function

01 Remote controller Operation in remote controller temperature sensor

02 Indoor unit Operation in indoor unit temperature sensor

03 2TH

Cooling

Operation of higher temperature by comparing indoor unit's and wired remote

controllerʼs temperature.

(There are products that operate at a lower temperature.)

Heating

Operation of lower temperature by comparing indoor unit's and wired remote

controller's temperature.

Part 2 Functions & Controls

LG CM24 N14 Svc Manual

Other manuals for LG CM24 N14