LG Code Zero A9 Series - How to Use; Installing the Wall-Mount Charging Station; Uninstalling the Charging Station

-15-
How to use
CAUTION
•
Avoid dropping the product and parts when taking them
out of the package. It may damage the product and/or
cause personal injury.
•
Do not use double-sided tape to anchor the charging
station on papered walls. Please use the provided screws
as otherwise the wall paper will get torn by movement of
the charging station during the docking of the unit.
•
We recommend anchoring the station with the anchoring
screw.
•
Use the anchoring screws only when the wall is made of
concrete or is solid enough. An unsuitable wall can cause
the mountings to weaken and cause the Charging station
to fall causing injury and damage the property or product.
•
Do not store the product or battery in the accessory bag
except for the inlet ports and flexible hose extension.
•
Be careful not to throw or drop the accessory bag carrying
accessories such as the inlet ports. It may damage the
product and/or cause personal injury.
•
* The accessory bag is provided only for an applicable
model.
Please note
•
The charging station, its pipe and support cannot be
disassembled separately once they have been assembled,
and the charging station has been attached to the wall.
•
If necessary, the charging station and the nozzle cradle
can be separated from the charging station pipe. Pull the
charging station upward and separate it in sequence while
the charging station support is in a fixed state.
Installing the wall-mount station
1
Connect the power adapter to the port on the back of
the charging station and plug the power cord into the
power outlet.
2
Ensure that there are no Electrical wires or water pipes
inside the wall where the wall mount bracket will be
attached to. By drilling or screwing, make a hole 1 meter
from the floor to insert the wall plug or screw anchor.
•
Recommended diameter of hole:
Φ
6.5; Recommended
depth: 60 mm.
3
Anchor the station to the wall with the provided
anchoring screws.
1
Wall anchoring
hole
Anchoring
screw for wall-
mount type
Screw
anchor
Please note
•
A service request to change the installation location of the
charging station will incur additional costs if required to do so
by a qualified installer.
•
The Detachable stand for the nozzles and the Detachable
stand for mop pads cannot be separated once they are
assembled.
Uninstalling the station
Keep and charge the product on the charging station after
separating extension pipe and nozzle from the product body.
CAUTION
•
Leaving the extension pipe and nozzle assembled for a long
time may cause damage the product.