-21-
How to use
Mop Nozzle
It is suitable for cleaning dust and mop cleaning at the same time.
Please note
The mop pads will only rotate at one speed regardless of
what power setting the Vacuum is set to.
For mop cleaning
How to fill the water
1
Press the PUSH button to separate the mop nozzle
and the water tank.
2
Open the cap on the side of the water tank.
•
Open one cap only. Opening both caps may cause
the water to flush.
3
Fill the water to the MAX line and close the cap tightly.
(Using the water filler jug will make the filling of water easier.)
•
If the water tank is filled with water and stored, water
may slowly drip from the water tank and on to the air
intake. When not using the mop nozzle, ensure that the
water tank is empty empty.
•
If you do not close the cap on the side of the water tank,
water may leak.
Good) Bad)
4
Assemble the mop nozzle and the water tank. Insert
the 2 bumps in front of the tank and push until a
clicking sound is heard.
Click
How to install the mop
1
Wet the mop pad with water before use.
2
Squeeze the mop pad sufficiently to remove liquid.
3
Align the center of the mop pad with the center of the
mop attachment plate, and have the striped side of
the mop face up.
•
Fitting the mop plate upside down or failure to attach the
mop pad to the attachment plate properly may compro
-
mise the cleaning performance.
•
Attaching the mop pad in a dry state may compromise the
cleaning performance.
※
How to install the mop pad properly
Good) Bad)
How to adjust the water flow to the Mop Pads
The amount of water injected from the mop nozzle can be
adjusted.
Used to clean a moisture-sensitive floor
or to supply a little amount of water
Used to clean ingrained dirt or to supply
a large amount of water
Used to stop the supply of water or
clean with a dry mop
To Next Page
Loading...
