LG Code Zero A9 Series - How to Use; Dry Mop Cleaning Procedure; Mop Cleaning Usage Notes

-22-
How to use
For dry mop cleaning
1
Empty the water in the water tank.
2
Attach the dry mop pad to the mop attachment plate
at the bottom of the mop nozzle.
3
Set the Water Adjustment button to STOP.
4
Turn on the power and begin mopping
WARNING
•
Do not insert your hand into the moving rotor. It may
result in injury.
•
Do not attach the mop pad while the mop nozzle is
operating. It may result in injury.
CAUTION
•
Do not slam down or throw the mop nozzle onto the floor.
Doing so may result in an injury or product damage.
•
Do not let the product stand on the floor while the wet
mop plates are attached.
Doing so may result in damage or swelling to timber
flooring.
•
Set the Water Adjustment button to STOP when not
using the product for an extended period of time.
Otherwise it may result in a product failure.
•
Do not use any other mop pad other than the one
provided.
•
Do not put liquid other than water in the water tank.
•
Do not put hot water in the water tank.
•
Do not step on the mop nozzle. It may result in product
damage
•
After cleaning, remove the remaining water in the mop
nozzle with a tissue before storing. The water may leak
and damage the floor.
•
Do not pull on the marked rubber. It may tear.
Please note
•
When using a mop, clean using straight lines and diagonal
lines.
•
Wet the mop and squeeze it sufficiently to remove any
residual water before attaching the mop.
Attaching and using a mop pad in a dry state may
compromise the cleaning performance.
•
When filling the water tank with water, do not fill the
water more than the MAX line.
•
Do not separate the cap of the water tank completely.
•
Open only one cap of the water tank to fill the water.
•
When cleaning is completed, always empty the water in
the water tank.
Otherwise the water may be contaminated and give off a
bad smell.
Shake the water tank to remove the remaining water.
•
Open the 2 caps on the side of the water tank and dry for
over 24 hours in a well-ventilated location with no direct
sunlight.
•
When cleaning with the mop is finished, separate and
wash the mop pads.
Otherwise the mop pads may give off a bad smell.
•
Do not clean while a soiled mop pad is installed.
Cleaning will not be effective.
•
From new, the Water Adjustment button is set to Level 1.
Press the button according to the amount of water
needed.
•
When moving around with the mop nozzle, set the Water
Adjustment button to STOP.
•
If there are foreign objects stuck in the mop attachment
plate's rotating mechanism or a strong force or impact
is applied to it, the mop attachment plate will stop
automatically to protect the product.
Press the Power button again to use the product because
it is not a failure. Clean any foreign matter from the plate
before turning it back on again.
•
Use the mop pads for general cleaning or the mop pads
for cleaning stubborn stains for their specific purpose to
clean more effectively.
Mop pads for general
cleaning
Mop pads for cleaning
stubborn stains