16
Getting to know your phone
Charging your phone
1 Connect the wall adapter and USB cable as shown below. The USB symbol
on the USB cable should face toward you.
2 Plug the USB cable (as shown below) into the phone's Charger/Accessory
Port. Make sure the USB symbol is facing upwards.
Always unplug the charger from the wall socket after the phone is fully charged
to save unnecessary power consumption of the charger.
NOTE:
• The battery must be fully charged initially to improve battery lifetime.
• Your phone has an internal antenna. Be careful not to scratch or damage
this rear area, as that will cause loss of performance.
• When the battery becomes fully discharged and you connect the phone to
a charger, the Notification LED lights will blink. This is normal operation for
a completely discharged battery to prevent overflowing current because the
phone is designed to provide reasonable protection against damage to the
battery. Once the battery has enough charge, the screen will turn on and
display a battery image.
To Next Page
Loading...
