22
System setting
3
Progressive Scan (For Component
Video connections)
Selects whether the COMPONENT VIDIO
(PROGRESSIVE SCAN) OUTPUT jacks progressive
signal. If your TV accepts progressive format signals,
you will enjoy accurate color reproduction and high
quality image by selecting [On]. If your TV does not
accept progressive format signals, select [O ].
If you set Progressive Scan to [On] in error, you must
reset the unit. First, remove the disc in the unit.
Next, press and hold STOP
Z
for ve seconds.
The video output will be restored to the standard
setting, and a picture will be visible on your TV.
Audio
2.1 Speaker Setup
Make the following settings for the built-in 2.1
channel surround decoder.
1. Select [2.1 Speaker Setup] on the [Audio] menu.
2. Press
b
ENTER.
The [2.1 SPEAKER] appears.
3. Use
AD
to select the desired speaker.
4. Adjust options using
WSAD
buttons.
5. Returns to the previous menu by pressing
x
RETURN.
[Speaker]
Select a speaker that you want to adjust.
Certain speaker settings are prohibited by the
Dolby Digital licensing agreement.
,
Note
[Size]
Since the speaker settings are xed, you cannot
change the settings.
[Volume]
Adjust the output level of each speaker.
[Distance]
Adjust the distance between each speaker and
the listening position.
[Speaker Test Start]
Select [Speaker Test Start] by using the
WS
and press
b
ENTER. Press
b
ENTER again to
stop. Adjust the volume to match the volume
of test signals memorized in the system.
SPK type changed_DM5540-FU_DPHLLLK_2013.12.07.indd 22 2013-12-19 6:56:06
To Next Page
Loading...
