Before servicing ask the customer what the trouble is.
Check the adjustments. (Power supply :220-240V~, Removal of transit bolts etc..)
Check the troubles referring to the troubleshooting.
Decide service steps referring to disassembly instructions.
Then, service and repair.
After servicing, operate the appliance to see whether it works OK or NOT.
7.TROUBLESHOOTING
7-1. CHECK BEFORE SERVICE
7-2. LOAD TEST MODE
1
Turn on, and touch ‘Pre Wash’ and ‘Crease Care’
at the same time in 1 second.
2
The washer must be empty and the controls must be in the off state.
3
Touch Power with above two buttons pressed and then buzzer will sound.
4
Touch the Start/Pause button repeatedly to cycle through the test modes
1
2
3
4
5
6
Display StatusNumbersCheck PointRemark
0
1
2
3
4
5
6
7
8
9
10
11
12
13
Turns on all light and locks the door.
Tumble clockwise (right)
Tumble clockwise (left)
Low speed spin
High speed spin
Inlet valve for prewash turns on.
Inlet valve for main wash turns on.
Inlet valve for hot water turns on.
Inlet valve for dry turns on.
Heater turns on for 3 sec.
Circulation pump turns on.
Drain pump turns on.
Dry Fan/Dry Heater turns on
Off
PGM Version Information
rpm(42~50)
rpm(42~50)
rpm (60)
rpm (110~120)
Water level frequency
Water level frequency
Water level frequency
Water level frequency
Water temperature
Water level frequency
Water level frequency
Dry Fan 6min./Dry Heater 5min.
-
To Next Page
Loading...
Need help?
General
