23
ERROR SYMPTOM CAUSE
MOTOR LOCKED
ERROR
• The connector in the LEAD WIRE ASSEMBLY is
not connected to the connector of STATOR
ASSEMBLY.
Reconnect or repair the connector.
•The hall sensor is out of order/defective.
Replace the STATOR ASSEMBLY Page 34
8
POWER
FAILURE
• The washer experienced a power failure
Press the start/pause button
9
• The Dry Heater is out of order
• The Connector of the Dry Heater is not connected
properly to the cinnector in the Main PWB ASSEMBLY
• The Dry fan motor is out of order Page 37
DRY HEATER
ERROR
10
NOTE
When you paused the machine under drying cycle, drying fan motor can be operated to save itself for 30
seconds. And then the machine displays “ ” on the panel.
To Next Page
Loading...
Need help?
General
