14
Connecting Hose to Water Tap
Connecting screw-type hose to tap with thread
Screw the hose connector onto the water supply tap.
Connecting screw-type hose to tap without
thread
1
Loosethefourxingscrews.
Upper
connector
Rubber
seal
Fixing screw
2
Removetheguideplateifthetapistoolargetot
the adapter.
Guide plate
3
Push the adapter onto the end of the tap so that
the rubber seal forms a watertight connection.
Tightenthefourxingscrews.
4
Push the inlet hose vertically upwards so that the
rubber seal within the hose can adhere completely
to the tap and then tighten it by screwing it to the
right.
Plate
Inlet hose
Connecting one touch type hose to tap without
thread
1
Unscrew the adapter ring plate and loose the four
xingscrews.
Ring plate
2
Removetheguideplateifthetapistoolargetot
the adapter.
Guide plate