25
ENGLISH
Option Cycle
Time Delay
You can set a time delay so that the washing machine
willstartautomaticallyandnishafteraspeciedtime
interval.
1
Press the Power button.
2
Select a washing program.
3
Press the Time Delay button and set time required.
4
Press the Start/Pause button.
NOTE
•
The delay time is the time to the end of the
program, not the start. The actual running time
may vary due to water temperature, wash load
and other factors.
Turbo Wash™
Use this option to save washing time.
1
Press the Power button.
2
Select a washing program.
3
Press the Turbo Wash™ button..
4
Press the Start/Pause button.
NOTE
•
Turbo Wash™ function of some courses is
selected automatically.
Add Item
Use this function to add loads or remove the foreign
material.
1
Press the Add Item button.
2
Close the door after add loads or remove the
foreign material (e.g. coin or pin etc.)
3
Press the Start/Pause button.
•
Results when choosing Add Item during cycles.
- When the tub is spinning : Tub stops and Door Lock
is off.
- When water temperature in the tub is higher than
45°C : Add Item is not available with short warning
sound for safety.
- When lots of water is in the tub : Door Lock is off
after draining by safe water level.
NOTE
•
Open the door when Door Lock is off after
checking the safety.
•
Add Item doesn't work when Tub Cleaning course
is in progress for safety.
•
Put the laundry into the tub completely. Laundry
caught in between door closing part can damage
door packing (rubber part) and might cause failure.