13
INSTALLATION
ENGLISH
Installation Place
Requirements
Before installing the appliance, check
the following information to make sure
that the appliance should be installed in
a correct place.
Installation Location
• This appliance must be installed on
firm flooring to minimize vibration
during the spin cycle. Concrete
flooring is best, being far less prone to
vibration during the spin cycle than
wooden floorboards or a carpeted
surface.
• If it is impossible to avoid positioning
the appliance next to a gas cooker or
coal burning stove, an insulation (850 X
600 mm) covered with aluminum foil
on the side facing the cooker or stove
must be inserted between the two
appliances.
• Ensure that when the appliance is
installed, it is easily accessible for an
engineer in the event of a breakdown.
• When installing the appliance, adjust
all four feet using spanner to ensure
the appliance is stable.
• Ensure that there is enough room for
full opening of the appliance door.
• To ensure sufficient clearance for
water inlet hoses, drain hose and
airflow, allow minimum clearances of
at least 20 mm at the sides and 100
mm behind the appliance. Be sure to
allow for wall, door, or floor moldings
that may increase the required
clearances.
• This appliance must only be used for
domestic household purposes and
should not be used in mobile
applications.
Ventilation
• Make sure that air circulation around
the appliance should not be impeded
by carpets, rugs, etc.
Ambient Temperature
• Do not install the appliance in rooms
where freezing temperatures may
occur. Frozen hoses may burst under
pressure. The reliability of the
electronic control unit may be
impaired at temperatures below
freezing point.
• If the appliance is delivered in winter
and temperatures are below freezing,
place the appliance at room
Index Clearance (mm)
A
100
B
5
C
20
To Next Page
Loading...
Need help?
General
