36
MAINTENANCE
To clean the pump filter
1
You may use the washing powder
spade (*) supplied with your machine
or liquid detergent level plate to open
the pump cover.
2
Lodge the end of the powder spade
or liquid detergent level plate in the
opening of the cover and gently press
backwards. The cover will open.
• Before opening the filter cover,
place a container under the filter
cover to collect any water left in the
machine.
• Loosen the filter by turning
anticlockwise and remove by
pulling. Wait for the water to drain.
• Depending on the amount of water
inside the machine, you may have to
empty the water collection container a
few times
3
Remove any foreign materials from
the filter with a soft brush.
4
After cleaning, re-fit the filter by
inserting it and turning clockwise.
5
When closing the pump cover, ensure
that the mountings inside the cover
meet the holes on the front panel
side.
6
Close the filter cover.
• Be careful when draining, as the water
may be hot.
Cleaning the Dispenser
Drawer
Detergent and fabric softener can build
up in the dispenser drawer. Liquid
detergents can remain under the
dispenser drawer and not dispense
completely. Remove the drawer and
inserts and check for build-up of
cleaning products
every 2 months
.
1
Pull the drawer forwards until it is
fully extended.
2
Press the region shown below inside
the detergent drawer you have pulled
all the way back, and continue pulling
To Next Page
Loading...
