What to do if the 'OUT OF FREQUENCY' message appears on my LG Flatron 775FT Monitor?
If your LG Monitor displays an 'OUT OF FREQUENCY' message, it means the video card signal frequency is outside the monitor's operating range. You should use the graphics board's utility software to adjust the frequency setting.
Why does my LG Flatron 775FT Monitor display an abnormal picture?
If your LG Monitor displays an abnormal picture, especially when using a non-VESA standard video card, try setting the monitor to one of its factory preset modes. Alternatively, select a resolution and refresh rate that falls within the monitor's specified limits.
Why doesn't my LG Flatron 775FT Monitor enter power saving mode?
Your LG Monitor might not enter power saving mode because the computer video signal isn't following the VESA DPMS standard. This indicates that either the PC or the video controller card isn't utilizing the VESA DPMS power management function.
How to fix the SELF DIAGNOSTICS message on my LG Flatron 775FT Monitor?
If you are seeing a SELF DIAGNOSTICS message on your LG Monitor, it typically means the signal cable isn't properly connected or is loose. Ensure the cable is securely connected at both ends.
Why is the power LED on my LG Flatron 775FT amber?
An amber power LED on your LG Monitor indicates that there's no active signal coming from your PC or that the signal cable isn't securely fastened. Check both the computer power and the graphics adapter configuration.
General| Display Type | CRT |
|---|---|
| Maximum Resolution | 1280 x 1024 |
| Refresh Rate | 85 Hz |
| Aspect Ratio | 4:3 |
| Dot Pitch | 0.24 mm |
| Max Resolution | 1280 x 1024 |
| Vertical Refresh Rate | 50 - 160 Hz |
| Input Signal | Analog |
| Input Connector | 15-pin D-Sub |
| Power Consumption | 70 W |
| Screen Size | 17 inch |
| Input Connectors | 15-pin D-Sub |
To Next Page
