A13A13
Connecting to External Devices
When connecting with a DVI signal input cable.
• Select DVI
When connecting with a D-SUB signal input cable.
• Select
RGB
Turn on power by touching the Power On/Off sensor on the product.
Turn on the PC.
Select an input signal.
Press the Input Select button on the remote controller to select the input signal.
Or, press the SOURCE button at the front side of the monitor.
B
A
•
How to connect to two computers.
Connect the signal cables (DVI and D-Sub) to each computer.
Press the SOURCE button in a remote controller to select the computer to use.
•
Directly connect to a grounded power outlet on the wall or a power bar with a ground
wire.
Note
Power On/Off sensor
INPUT SELECT
TV
AV
S-Video
Component
RGB
DVI
To Next Page
Loading...
Need help?
General