LG FV1409D4V - User Manual

Questions and Answers

W
weavermichelleSep 5, 2025
Why does my LG Washer/Dryer show 1E INLET ERROR?
- H
  Helen GeorgeSep 5, 2025
  The 1E INLET ERROR on your LG Washer/Dryer indicates an issue with the water supply. This could be due to several reasons: the water supply might be inadequate, the water supply tap isn't fully open, the water supply hoses are kinked, or the filters of the supply hoses are clogged. To resolve this, first check another tap in the house to ensure adequate water supply. Then, fully open the water supply tap. Inspect the water supply hoses for any kinks and straighten them or reinstall the hose. Finally, turn off the taps, remove the hose connections to the washing machine, and check and clean the inlet valve filter.
P
Patrick CoxSep 5, 2025
What to do if my LG FV1409D4V shows UE UNBALANCE ERROR?
- J
  Jason GriffinSep 5, 2025
  If your LG Washer/Dryer displays a UE UNBALANCE ERROR, it means the load is unbalanced. This can happen if the clothes are too wet at the end of the cycle or if the load is too small. To fix this, rearrange the load to allow proper spinning. If the load is too small, add 1 or 2 similar items or smaller articles of clothes to help balance it. After rearranging or adding items, close the door and press the Start/Pause button. Note that the door must be locked before the appliance begins to spin.
F
Frank LandrySep 6, 2025
What to do if I get UE unbalance error on LG FV1409D4V?
- T
  torresstephenSep 6, 2025
  If you get a UE UNBALANCE ERROR on your LG Washer/Dryer, it means the load is unbalanced. This might be because the laundry is too wet at the end of the cycle. Rearrange the laundry to allow proper spinning, then close the door and press the Start/Pause button. It could also be that the load is too small. Add 1 or 2 similar items or smaller articles of laundry to help balance the load, then close the door and press Start/Pause button.
J
jesusreedSep 7, 2025
Why is my LG Washer/Dryer not filling properly?
- C
  Carolyn BirdSep 7, 2025
  If your LG Washer/Dryer isn't filling properly, start by checking if the inlet filters on the fill valves are clogged. Also, make sure the inlet hoses are not kinked or clogged. Ensure both hot and cold water taps are turned on fully. Finally, verify the hot and cold inlet hoses are connected correctly.