Care and Maintenance
27
Check that the power cord is not damaged, power plug
has not overheated, and that the power plug is tightly
inserted into the outlet.
Cleaning
Before Cleaning
After Cleaning
Warning
Be sure to unplug the power.
As above.
Clean the outside of the fridge-freezer with a soft cloth
soaked with hot water or liquid detergent. If you use a
detergent, be sure to wipe it with a clean wet cloth.
Exterior
Interior
Grille and Drip
Tray
Exterior Dispenser
Cap Tank
(Big & Small)
Water Tank
1. Lift the Water Tank up by pressing the fixing Lever
on the bottom of Water Tank and then remove it.
2. After removing the Cap Tank (Big), clean and fully
rinse the inside/outside part of the Water Tank by
using neutral cleansing agent.
Wipe moisture etc out outside of Dispenser and on the
Dispenser Pad using a cloth.
Remove the Grille, wipe moisture out around the Door
part and the Drip Tray using a clean cloth.
Clean and fully rinse the Cap Tank (Big & Small) by using
neutral cleansing agent.
Especially for the groove part of the Cap Tank, it is
convenient to cleanse it by using a small brush.
Clean and fully rinse the Valve Assembly by using a
small brush. Rinse it while operating the bottom part of
the valve assembly. Always fix the Sealing Rubber
separated for cleansing at the existing position
(may result in water leakage).
Be sure to dry the appliance with a cloth after washing
it with water.
Do not use abrasive, petroleum, benzene, thinner,
hydrochloride acid, boiling water, rough brush, etc, as
they may damage parts of the fridge-freezer.
Valve Assembly
To Next Page
Loading...
Need help?
General
