23
NO
YES
YES
NO
YES
NO
YES
NO
NO
YES
NO
Main washer
Safterner
Is the tap opened?
Is the tap frozen?
Is the water supply shut-off?
Is filter in the inlet valve clogged with
foreign material?
Open the tap.
After separating the hose
from the washing machine
soak in hot water for 10
minutes.
Is resistance between each terminal of the INLET
VALVE ASSEMBLY 0.8-1.2
kΩ
?
Verify the voltage of the inlet valve connector is
120 V AC.
Refer to page 18, QC TEST MODE.
Replace the INLET
VALVE ASSEMBLY.
※Make sure the tap is closed before
replacing.
Check electrical connection.
Replace the MAIN PWB
ASSEMBLY.
IE ERROR (NO WATER SUPPLY)
Clean the filter of
INLET VALVE ASSEMBLY
To Next Page
Loading...
