13
INSTALLATION
Ambient Temperature
Install this appliance in an area where the
temperature is between 55°F (13°C) and 110°F
(43°C). If the temperature around the appliance
is too low or high, cooling ability may be
adversely aected.
Measuring the Clearances
Too small of a distance from adjacent items
may result in lowered freezing capability and
increased electricity consumption charges.
Allow at least 33 ¾ inches (86 cm) in front of
the refrigerator to open the doors, and at least
2 inches (5.08 cm) between the back of the
refrigerator and the wall.
2” (5.08 cm)
33 ¾ ” (86 cm)
Removing/Assembling the
Refrigerator Door Handles
Removing the Handles
1
Loosen the set screws with a
3
/
32
in.
(2.5 mm) Allen wrench and remove the
handle.
2
Loosen the mounting fasteners that
connect to the refrigerator door and handle
using a
1
/
4
in. (6.35 mm) Allen wrench, and
remove the mounting fasteners.
Assembling the Handles
1
Assemble the mounting fasteners at
both ends of the handle using a
1
/
4
in.
(6.35 mm) Allen wrench.
2
Place the handle on the door by tting
the handle footprints over the mounting
fasteners and tightening the set screws
with a
3
/
32
in. (2.5 mm) Allen wrench.
NOTE
When it is necessary to move the
refrigerator through a narrow opening,
removing the doors is the recommended
procedure. If it is necessary to remove the
handles, follow the directions below. The
appearance of the handle may vary from
what is shown in the illustrations.
ENGLISH
To Next Page
Loading...
Need help?
General
