19
INSTALLATION
Reversing Door Opening Direction
Reversing the Refrigerator Handle
1
Loosen the set screws with a
3
/
32
in.
(2.5 mm) Allen wrench and remove the
handle.
2
Loosen the mounting fasteners that
connect to the refrigerator door and handle
using a
1
/
4
in. (6.35 mm) Allen wrench, and
remove the mounting fasteners.
3
Carefully loosen the plug buttons
4
them counter-clockwise and continuing
until they loosen and fall out The buttons
were installed without pressure, and for
this reason, they can be unscrewed using
the plug buttons
5
on the left side.
4
Assemble the mounting fasteners at
both ends of the handle using a
1
/
4
in.
(6.35 mm) Allen wrench.
5
the handle footprints over the mounting
fasteners and tightening the set screws
with a
3
/
32
in. (2.5 mm) Allen wrench.
NOTE
To assist in the installation of the handle
on the right side, place a piece of
masking tape near the top of the handle
before removing it.
The appearance of the handle may
vary from what is shown in the illustrations.
4
5
ENGLISH
To Next Page
Loading...
Need help?
General
