LG GML960PYBE - Water Supply Requirements and Connection

16
INSTALLATION
NOTE
• If the water tube end is damaged, it should be
trimmed to ensure it does not leak when refitted.
e Not straight f Damaged g Stretched
Connecting the Water Line
This feature is only available on some models.
Water Supply Requirements
Connect the appliance to a cold water supply with a
maximum inlet water pressure not exceeding 1.0
MPa. A water pressure between 138kPa and
827kPa is recommended for the optimal operation
of the water dispenser. If the refrigerator is
installed in an area with low water pressure (below
138 kPa), you can install a booster pump to
compensate for the low pressure.
If a reverse osmosis water filtration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs to
be a minimum of 138 kPa.
WARNING
• Unplug the appliance before carrying out any
work on connecting the water line. Failure to do
so may cause electric shock.
• Only connect the water line to a cold water
supply. Failure to do so may cause the water
filter to malfunction. Water hammer (water
banging in the pipes) in house plumbing can
cause damage to appliance parts and can lead to
water leakage or flooding.
• Connect to potable water supply only.
• Connecting the water line must only be installed
by a qualified plumber and in accordance with
local legislation and regulations governing
water quality.
NOTE
• This water line installation is not covered by the
appliance warranty.
Connecting Water to the
Appliance
1 Unscrew the metal threaded collar nut at the
back of the appliance and place it over one end
of the water tube.
2 Firmly push the water tube onto the water inlet
valve and tighten up the collar nut.
Connecting to the Water Tap
This feature is only available on some models.
1 Push the water tube into the hole of the tap
connector supplied in the accessories. The pipe
Correct
Incorrect