5
Drive Operation
Inserting a Disc
• Press the eject button. The disc tray will be ejected.
• Place the disc in the center of the tray with the label side facing up.
• Push disc onto hub until secure.
• Push the disc tray by hand and close completely.
Removing a Disc
• Press the eject button. The disc tray will be ejected.
• Remove the disc.
• Push the disc tray till it closes completely.
NOTE: During some drive activities, the drive will not allow the tray to open even
when the eject button is pressed.
Usage Guidelines
• Do not press down on the disc tray when it is opening or closing.
• Do not place objects on the disc tray.
• Never use a damaged, broken, scratched, or deformed disc.
• Keep the disc tray closed when the drive is not in use.
NOTE: High-speed drives spin the disc at a high rotational speed. If a disc has
printing on only half of the disc, or if there is a slight imbalance in the disc, the
imbalance is greatly magnied by the high speed, causing the drive to vibrate or
produce a fan-like noise. These effects are inherent in the high-speed technology
and do not indicate a problem with the drive.
To Next Page
Loading...
Need help?
General
