- 98 -
LGE Internal Use Only Copyright © 2009 LG Electronics. Inc. All right reserved.
Only for training and service purposes
5. Trouble shooting
[Figure5.14 Schematic of Bluetooth Interface
G
Bluetooth RF Test procedure
1. Set phone to bluetooth test-mode.
- Bluetooth ON : Enter Test Mode(1809#*520#) Eng Mode BT Testing RF Test
2. Insert a phone in a TEMCELL (in case of radiation test)
3. Set ‘discover’ after push menu button of the tester and select the link analyzer .
4. After ‘set test mode’, confirm the connection state.
5. Measure the power of full channel after hopping mode is selected to ‘ON’
6. You can select wanted test cases after getting an optimized power
7. Bluetooth Off
- Menu(OK key) setting 4)Connectivity 1)Bluetooth 1)Turn on/Turn off