LG GX200 - 10 Engineering Mode

-160-
10.Engineering Mode
1.1. Enter and Exit Engineering Mode
In idle screen, enter the Factory Mode menu by typing “*2945#*#”. Like normal menu
operations, press Left-Soft-Key (LSK) “Back” to the previous screen or End key to go back
to the idle screen.
1.2. Version
Version info summary: Software version number, software codebase branch, build time
info.
MCU SW: Software version number
Melody: melody version
Serial No. :Serial number.
BB chip: Base band chip info.
1.3. Network Setting
1.3.1. Network Info
This function is for engineers to monitor the status of the protocol stack and interactions
with the network. Use LSK ok to toggle the value of a selected item. After selection of
items to monitor is complete,press RSK Back. If any settings are changed,a screen
appears with “Update Parameter?”. Pressing LSK Yes saves the new values to the
protocol stack;Pressing RSK NO discards all changes.These settings are not stored in
NVRAM;thus the settings are lost if the handset is powered off.
Item Function Selection Value Description
RR Cell Sel On/Off Radio Resource cell selection
information
RR Ch Dscr
On/Off Radio Resource channel
description information
RR Ctrl Chan On/Off Radio Resource control channel
information
RR RACH Ctrl On/Off Radio RACH control channel
information
RR LAI Info On/Off Radio Resource LAI information
RR Radio Link On/Off Radio Resource radio link
information
RR Meas Rep On/Off Radio Resource measurement
report information
CC Chan Info On/Off Call Control Channel information
CC Call Info On/Off Call Control Call information
CA List Info On/Off CA List information
PLMN Info On/Off PLMN information
GPRS Info On/Off GPRS information
Si2Q/Mi Info On/Off Si2Q/Mi information
TBF Status On/Off TBF Status
Network
Info.
Block Info On/Off Block information
1.3.2. Band Selelct