-165-
register.For example: If the MS is in Normal Mode and the current speech volume
level is LEVEL4,updating the parameter sets the gain value of LEVEL4 of Speech to
the hardware register.
5. To change the current volume level of Speech ,use side key when in call.
6. To change the current volume level of Key tone,use side key when in idle screen.
7. To change the current level of Ring tone,enter User Profiles->[Active
Mode]->Customize->Volume->Ring tone to change volume.
8. The parameters of Headset Mode are applied only when the headset is plugged in.
9. The parameters of LoudSp Mode are applied only when handsfree is turned on
during a call.
1.5.2. Ring Tone
This audio setting is used to demonstrate all melodies on the MS,including
iMelodies,Midis and Sounds(MIDI format). Use the up and down keys to scroll over the
ring tones: highlighting a selection longer than one second plays the ring tone.
1.5.3. Speech Enhancement
You can set the Common Parameters 0~7.
There are 8 Mode for selection :Normal Mode,Headset Mode,LoudSp Mode,BT
Earphone Mode,BT Cordless Mode,AUX1 Mode,AUX2 Mode,AUX3 Mode. The 8 Mode
have 0~15 parameter to set.
1.5.4. Max Swing
This setting sets the maximum swing value.
1.5.5. Debug Info
The setting sets the Debug information parameter :0~15.
1.5.6. Auto Record Setting
The Setting includes: VM Support, Auto Speech Record.
You can turn on/off them.
1.6. GPRS Activation
This menu is for GPRS mode test only (if supported).
1.6.1. Attach
To start GPRS attach.
1.6.2. Activate PDP
To activate GPRS PDP context1-15.
To Next Page
Loading...
