Installing and Composition
14
Selecting input mode
1. Press the INPUT button on the top cover or the INPUT button on the remote control.
2. Selecting an input signal with the INPUT button will only change the projector only to connected inputs. You can
change it to any inputs with the ＜, ＞ button.
• The component input is always active, and it does not support plug &play function.
Input List
Component Video RGB HDMI
Turning on the Projector
1. Make sure the power cord is connected correctly.
2. Press the POWER button on the top cover or the POWER button on the remote control. (The light on the control
panel will be turned on.)
• Press the INPUT button on the remote control or the INPUT button on the control panel to select the input signal you want.
• When you press the POWER button on the remote control or the POWER button on the control panel when you turn on the
projector, the lights for all buttons on the control panel will be turned on.
Turning off the Projector
Press the POWER button on the top cover or the POWER button on the remote control.
When an image appears on the screen, check if it is in focus and fits the screen properly.
• To adjust the focus of the image, rotate the focus ring.
Focus ring
Focus and Position of the Screen Image
To Next Page
Loading...
Need help?
General
