LGE Internal Use Only
Copyright © 2008 LG Electronics. Inc. All right reserved.
Only for training and service purposes
3.7 KEYPAD Interface
The keypad interface is connected to the X-Bus, together with the XBIU and the Shared Memory
Register, using a single Bus Interface.
The keypad supports two scan modes:
• By default, the keypad is a 4x6 scan matrix (4 input and 6 output pins).
• To set the keypad to a 5x5 scan matrix (5 input and 5 output pins)
The scan mode should be determined at the very beginning of the system start because changes are
not allowed later.
3. TECHNICAL BRIEF
- 29 -
Figure 3-7 KEY MAXTRIX Interface
To Next Page
Loading...
