23INSTALLATION
ENGLISH
Leveling Dishwasher
Check that the dishwasher is level and adjust the
leveling feet if necessary.
CAUTION
• Failure to level the dishwasher may result in
leakage, problems closing the door, or noise.
• Where the cabinet opening is narrower than
recommended (see Preparing Cabinet
Opening), the dishwasher must be carefully
leveled and aligned so that the dishwasher is
supported fully by the 3 leveling feet and is not
hanging from the installation brackets. Failure
to do so can result in leaks from the front of the
dishwasher, AE errors, difficulty in closing the
door, or failure to operate.
Checking Leveling
To check that the tub is level from front to back,
remove the lower rack and pour 169 oz. (5 L) of water
into the bottom of the tub. The water level should be
near the center of both tub lower indentations at the
front.
With the lower rack removed, place a level on the
inside wall of the tub to check that the dishwasher is
level from side to side.
• If you do not have a level, try using a smartphone
level application instead.
Make sure that the gap between the tub walls and the
door liner is the same on either side.
To Next Page
Loading...
Need help?
General
