REFRIGERATOR INSTALLATION
INSTALLATION
Installation is relatively straight-forward.
• Use at least two people to move and install this refrigerator.
• Do not lay the refrigerator on its side to store or transport it.
• Leave the refrigerator in the factory packaging until it is delivered to the
place of installation.
• Unbox and unpack the refrigerator. Make sure no small parts or
accessories are thrown away in the packing.
• Make sure the leveling legs are in the highest position before moving.
(See page 13.)
• Do not roll the refrigerator across pavement, gravel, or rough surfaces.
The wheels will be damaged and will, in turn, damage the customer’s floor.
• Roll the refrigerator to the installation area. If you have to remove the
doors, there is a section in the manual covering that. (See pages 20-21.)
Be cautious to avoid damaging the refrigerator or the flooring!
• Connect the water line, if applicable. Turn on the water and check for
leaks. There is a section in this manual covering that. (See page 15.)
• Roll the refrigerator into place.
• Level the refrigerator by lowering the leveling legs and taking the weight
off the front rollers. The doors can be evened using this same procedure.
(See page 13.)
• Install the lower cover (kick plate or base grille). (See page 14.)
• Plug in the refrigerator.
• Install all the shelves, door bins, and accessories in the desired places.
Set the desired temperature.
• Allow 24 hours for the refrigerator to cool down, stabilize its temperature,
and begin making ice.
LFX21960ST/LFX25960xx Page 11 of 75 TRAINING MANUAL
To Next Page
Loading...
