REFRIGERATOR DISASSEMBLY
FREEZER LAMP
1. Unplug the refrigerator before
working on it.
2. Removing the shelves should
not be necessary.
3. Unscrew the bulb(s) and
replace. Use a 60-watt bulb
maximum.
4. Replace the lamp shield and the
tabs will click into place.
MULTI DUCT
1. Remove the upper and lower
caps using a small screwdriver.
2. Remove the two screws holding
the duct in place.
3. Pull the duct away from the back
of the refrigerator from the top.
4. Disconnect the lead wire at the
bottom of the duct before pulling
the duct out any farther.
5. Replacement is the reverse of
disassembly.
LFX21960ST/LFX25960xx Page 27 of 75 TRAINING MANUAL
To Next Page
Loading...
