LG LMXS30776 Series - Removing;Assembling the Freezer Drawer Handle; Removing;Assembling the Doors and Drawers

13
INSTALLATION
ENGLISH
WARNING
%
If your entrance door is too narrow for the
refrigerator to pass through, remove the
refrigerator doors and move the refrigerator
sideways through the doorway.
%
Use two or more people to remove and
install the refrigerator doors. Failure to do
so can result in back or other injury.
%
Disconnect the electrical supply to the
refrigerator before installing. Failure to do
so could result in serious injury or death.
%
Do not put hands, feet or other objects into
the air vents or bottom of the refrigerator.
You may be injured or receive an electrical
shock.
%
Be careful when handling the hinge and
stopper, to avoid injury.
%
Remove food and bins before detaching the
doors and drawers.
Removing/Assembling the
Doors and Drawers
When it is necessary to move the refrigerator
through a narrow opening, removing the doors
is the recommended procedure.
WARNING
When assembling or disassembling the
handle:
%
Grasp the handle tightly to avoid dropping it.
%
Do not swing the handle into nearby people
or animals.
%
Make sure that the bracket hole of the
handle fits properly into the stopper bolt of
the door. Assemble the set screws to fix
the handle into place.
%
Make sure that there is not a gap between
the door and handle after assembling the
handle.
Removing/Assembling the
Freezer Drawer Handle
Removing the Handle
1
Loosen the set screws located on the
lower side of the handle with a
1
/
8
in. Allen
wrench and remove the handle.
2
Loosen the mounting fasteners that
connect to the
freezer drawer
and handle
using a
1
/
4
in.
Allen wrench,
and remove
the mounting
fasteners.
Assembling the Handle
1
Assemble the mounting fasteners at
both ends of the handle using a
1
/
4
in. Allen
wrench.
2
Place the handle on the door by fitting
the handle
footprints over
the mounting
fasteners and
tightening the
set screws
with a
1
/
8
in.
Allen wrench.