58
LIMITED WARRANTY
•
Damage or failure caused by use that is other than normal household use, including, without limitation, commercial
or industrial use, including use in commercial offices or recreational facilities, or as otherwise outlined in the
Product’s owner’s manual;
•
Damage or failure caused by transportation and handling, including scratches, dents, chips and/or other damage to
the finish of the Product, unless such damage results from defects in materials or workmanship and is reported to
LGECI within one (1) week of delivery of the Products;
•
Damage or missing items to any display, open box, refurbished or discounted Product;
•
Refurbished Product or any Product sold “As Is”, “Where Is”, “With all Faults”, or any similar disclaimer;
•
Products with original serial numbers that have been removed, altered or cannot be readily determined at the
discretion of LGECI;
•
Increases in utility costs and additional utility expenses in any way associated with the Product;
•
Any noises associated with normal operation of the Product;
•
Replacement of light bulbs, filters, fuses or any other consumable parts;
•
Replacement of any part that was not originally included with the Product;
•
Costs associated with removal and/or reinstallation of the Product for repairs; and
•
Shelves, drawers, handle and accessories to the Product, except for internal/functional parts covered under this
Limited Warranty.
•
Conversion of products from natural gas or L.P. gas;
•
Coverage for "in Home" repairs, for products in-warranty, will be provided if the Product is within a 150 km radius
from the nearest authorized service center (ASC), as determined by LG Canada. If your Product is located outside
a 150 km radius from a ASC, as determined by LG Canada, it will be your responsibility to bring the Product, at your
sole expense, to the ASC for in-warranty repair.
Not Covered by this Limited Warranty
Problem Cause Prevention
•
Cooktop enamel
chipping off
Improper usage
•
Do not hit enamel cooktop
•
Burners do not light Clogged or dirty burner ports or electrodes will
not allow the burner to operate properly
•
Check and clean the gas
electrode.
OK Not working
Must be cleaned
•
Uneven flame 1. Improper burner cap installation
•
Check installation of burner
head and cap
Burner cap is
properly seated.
Burner cap is NOT
properly seated.
2. Burner ports clogged by food residue
•
Hardened residue should be
removed using a toothbrush.
Ports blocked by dirt Flames uneven
To Next Page
