-39-
Warning :
Disconnect the unit from power supply before making
any checks.
Be sure the power switch is set to “OFF”.
To remove the Grille from the Chassis
• Set the up-and-down air discharge louver to open
position (horizontally) by finger pressure.
• Remove the securing screws
• To remove the Grille, pull the lower left and right side
of the grille toward you (slightly tilted) and lift it
straight upward.
To remove the Grille from the Chassis
• Remove the cover control➀ from the grille➁.
• Separate the black lead wire from the white
connector.
• Remove screws secured (➂ 3 EA).
• Pull the grille➁ out from the chassis carefully.
1. To remove the sensor, housing connect, earth
conductor & step motor conductor with sensor
holder, Motor, Evaporator & P.C.B.
■ LS-L1262CL/HL
To Next Page
Loading...
