Copyright Information 130
expressed in units of watts per kilogram (W/kg). The FCC requires wireless phones to comply
with a safety limit of 1.6 watts per kilogram (1.6 W/kg). The FCC exposure limit incorporates a
substantial margin of safety to give additional protection to the public and to account for any
variations in measurements. Tests for SAR are conducted using standard operating positions
specified by the FCC with the phone transmitting at its highest certified power level in all tested
frequency bands. Although SAR is determined at the highest certified power level, the actual
SAR level of the phone while operating can be well below the maximum value. Because the
phone is designed to operate at multiple power levels to use only the power required to reach
the network, in general, the closer you are to a wireless base station antenna, the lower the
power output.
Before a phone model is available for sale to the public, it must be tested and certified to the
FCC that it does not exceed the limit established by the government adopted requirement for
safe exposure. The tests are performed in positions and locations (e.g., at the ear and worn on
the body) as required by the FCC for each model. The FCC has granted an Equipment
Authorization for this model phone with all reported SAR levels evaluated as in compliance with
the FCC RF emission guidelines.
SAR information on this model phone is on file with the FCC and can be found under the
Display Grant section of http://www.fcc.gov/oet/ea/fccid/ after searching on FCC ID
ZNFLS665.
To find information that pertains to a particular model phone, this site uses the phone FCC ID
number which is usually printed somewhere on the case of the phone. Sometimes it may be
necessary to remove the battery pack to find the number. Once you have the FCC ID number
for a particular phone, follow the instructions on the website and it should provide values for
typical or maximum SAR for a particular phone. Additional information on Specific Absorption
Rates (SAR) can be found on the Cellular Telecommunications Industry Association (CTIA)
website at http://www.ctia.org/
*In the United States and Canada, the SAR limit for mobile phones used by the public is 1.6
watts/kg (W/kg) averaged over one gram of tissue. The standard incorporates a substantial
margin of safety to give additional protection for the public and to account for any variations in
measurements.
FCC Notice
Part 15.19 Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
To Next Page
Loading...
