Move the Pushthe refrigeratorsidewaysthrough the
Refrigerator entrancedoor asshown in the right picture.
Before
Installation
[]Warning
Connecting
the Refrigerator
to a Water Source
Tools Required
Screwdriver
Electric drill
Door replacement
Mount the doors in the reverseorder of
removal after the refrigerator is brought to
the installation area.
Feed water tube installation
• Automatic icemaker operation needs water pressure of 21.3-121psi(Ib/inch 2) (That
is, a 7oz. paper cup will be filled within 3 sec.).
• If water pressure does not reach the rated 21.3psi(Ib/inch 2) or below, it is necessary
to purchase a separate pressure pump for normal automatic icemaking and cool
water feed.
• Keep the total length of the water feed tube within 40 feet and be careful not to
bend or kink the tube. If the tube is longer than 40 feet, the icemaker and water
dispenser will not operate properly.
• Install the water feed tube at a place free from heat.
Water Connection Instruction Guide
Read all directions carefully before you begin.
• Standard screwdriver
• 7/16-inch and 1/2-inch open-end wrenches or two adjustable wrenches
• 1/4-inch nut driver
• 1/4-inch drill bit
• Hand drill or electric drill (properly grounded)
Adjustable wrenches
To Next Page
Loading...
Need help?
General
