Freezer
Compartment
Lamp
Dispenser Lamp
Freezer
Compartment
Shelf
Door Rack and
Support
Ice Storage Bin
After Dispenser
Is Used
How to Dismantle Parts
Remove cover by pressing upward on bottom
@ and rotating outward@.
Turn the bulb counterclockwise. Max. 40 Wbulb
for refrigerator is used and can be purchased at
a service center.
Seperatethe lamp by pulling it out, and then
remove the lamp. Max. 15 W bulb for
refrigerator is used and can be purchased at a
service center.
To remove a shelf, Lift the left part of the
shelf a bit. Lift it to the direction@ ,push the
right part to the direction@, and take it out.
Lift the door rack holding both sides@and
pull it out to@ direction.
Lift the ice shelf as shown in the right figure
@ and pull it out@
Hold the ice storage bin as shown in the right
figure and pull it out whiIeslightly lifting it.
To assemble the ice storage bin, push it ®
whileslightly liftingit ®,
• It is recommended not to dismantle the ice
storage bin unless it is necessary.
• Use both hands to remove the ice bin to avoid
dropping it.
• If the ice bin does not slide into )lace easily,
twist the drive device slightly.
The water collector has no self-draining
function. It should be cleaned regularly.
Remove the cover by pulling the front side of
water collector cover and dry it with a cloth.
Drive
ice
To Next Page
Loading...
