11INSTALLATION
ENGLISH
Tools Needed
a Phillips screwdriver
b Flat-blade screwdriver
c 1/4" Nut driver
d Pliers
e Tape measure
f Level
g Adjustable wrench
h Drill
i Safety glasses
j Gloves
Parts
Parts Provided
a Template (1)
b Anti-tip bracket kit (1)
c Anchor sleeves (4)
d Lag bolts (4)
Parts Not Provided
a 4-Wire cord or 3-Wire cord (UL approved 40 or
50 AMP)
b Strain relief (For conduit installations only)
• Observe all governing codes and ordinances.
• Have the installer show you the location of the
circuit breaker or fuse. Mark it for easy
reference.
• As when using any appliance generating heat,
there are certain safety precautions you should
follow.
• Be sure your range is installed and grounded
properly by a qualified installer or service
technician.
Unpacking and Moving the Range
• You should use two or more people to move and
install the range. (Excessive Weight Hazard)
Failure to do so can result in back or other injury.
• Do not use the door handles to push or pull the
range during installation or when moving the
range out for cleaning or service. Doing so can
result in serious damage to the door of the
range.
• To reduce the risk of burns, do not move this
appliance while it is hot.
• Remove packing material, tape and any
temporary labels from your range before using.
Do not remove any warning-type labels, the
model and serial number label, or the Tech
Sheet that is located on the back of the range.
• To remove any remaining tape or glue, rub the
area briskly with your thumb. Tape or glue
residue can also be easily removed by rubbing a
small amount of liquid dish soap over the
adhesive with your fingers. Wipe with warm
water and dry.
us_main.book.book Page 11 Thursday, June 17, 2021 8:05 AM
To Next Page
Loading...
Need help?
General
Weight and Dimensions
