LG LZ-H020GBA6 - Ventilation Product User Manual - Single Operation with General Ventilation

Installation manual 29
Test running
ENGLISH
Ventilation product user manual - Single operation with general ventilation
This function is to circulate the air in the room using a general ventilator.
Press
2
button on the remote controller.
1
Press
P
button to convert the ventilation
mode.
Press
N button in the Vent mode to
change the fan speed.
- Each time you press the button the fan
speed is selected in the order of low
→
high
→ power.
- If a CO
2 sensor is installed, you can
select the fan speed in the order of low
→
high
→ power → auto.
In the case of heat exchange mode is shown
below.
2
3
Single Operation with General Ventilation
→→→→→→→
Vent
mode
Remote
controller
display
window
Description
Heat
exchange
The fresh air entering the room is
heated or cooled by the air leaving
the room.
This mode is used when pre-
heating or pre-cooling improves
comfort and reduces energy
consumption.
Normal
The fresh air by-passes the heat
exchanger and enters the room at
outdoor temperature.
Auto
The system selects Heat exchange
or Normal automatically after
comparing indoor and outdoor
temperatures.