35
EXTERNAL EQUIPMENT SETUP
Connecting with an HDMI to DVI cable
Connect the DVI output of the PC to the HDMI/DVI IN1
or HDMI/DVI IN2 jack on the SET.
Connect the PC audio output to the AUDIO IN (RGB/
DVI) jack on the SET.
Turn on the PC and the SET.
Select HDMI 1 or HDMI 2 input source using the INPUT
button on the remote control.
1
2
3
4
1
2
►Connect the signal input cable and tighten it up by turning in
the direction of the arrow as shown in the figure.
NOTE
!
►If you want to use HDMI-PC mode, you must set the input label to PC mode.
To Next Page
Loading...
Need help?
General
