LG M227WDP - PRODUCT SPECIFICATIONS; APPLICATION RANGE; TEST CONDITIONS; TEST METHODS

No Item Specification Unit Remark
1 Type TFT Color LCD Module
2 Diagonal Size 21.53 inches diagonal
3 Active Display area 476.64(H) 268.11(V) mm
4 Outline Dimension 495.6(H) x 292.2(V) x16.5(D) mm Typ. (Without Inverter)
5 Aspect Ratio 16:9
6 Pixel Number 1920 x RGB x 1080 pixel
7 Pixel Pitch 0.248(H) x 0.248(V) mm
8 Color arrangement RGB vertical Stripe
9 Color Depth 16.7M color (6bit with A-FRC)
10 Electrical Interface LVDS 2Port
11 Surface Treatment Hard coating(3H) & Anti-glare(Haze 25)
12 Operating Mode Normally White
13 Backlight Unit 4 CCFL (4 lamps)
14 Response Time Rising Time : 1.3 + Falling Time : 3.7 ms Typ.
15 Color Gamut 72%
LGE Internal Use OnlyCopyright LG Electronics. Inc. All right reserved.
Only for training and service purposes
- 6 -
SPECIFICATION
NOTE : Specifications and others are subject to change without notice for improvement .
4. Module Specification
4.1 M227WDP-PZL : LGD,LM215WF-TLA1( P/N : EAJ60156901 / P6)
1. Application Range.
This spec sheet is applied to the 22”/ 23” LCD Monitor TV used
LD93C chassis.
2. Specification
Each part is tested as below without special appointment
2.1 Temperature : 25±5°C(77±9°F), CST : 40±5°C
2.2 Relative Humidity : 65±10%
2.3 Power Voltage : Standard input voltage
(100~240V@ 50/60Hz)
• Standard Voltage of each products is marked by models
2.4 Specification and performance of each parts are followed
each drawing and specification by part number in
accordance with BOM .
2.5 The receiver must be operated for about 5 minutes prior to
the adjustment.
3. Test method
3.1 Performance : LGE TV test method followed.
3.2 Demanded other specification
Safety : CE, IEC specification
EMC : CE, IEC
Safety : IEC/EN60065
EMI : EN55013
EMS : EN55020