11
Select an input signal.
Press the INPUT button on the remote control to select the input signal.
Or, press INPUT on the bottom of the set.
• How to connect to two computers.
Connect the signal cables (HDMI-DVI and D-Sub) to each computer.
Press the INPUT button on the remote control to select the computer to use.
• Directly connect to a grounded power outlet on the wall or a power bar with a ground wire.
Note
Turn on power by pressing the power button on the product.
Turn on the PC.
When connecting with a D-Sub signal input cable.
• Select RGB : 15-pin D-Sub analog signal.
When connecting with a HDMI-DVI signal input cable and HDMI Signal Cable.
• Select HDMI/DVI : DVI Digital signal or HDMI Digital signal.
Connecting to External Devices
INPUT → → OK
On/Off button
2.
1.
B.
A.
4
5
INPUT →◄ ► → AUTO/SET
Input List
AV Component RGB HDMI/DVI SuperSign
Input List
AV Component RGB HDMI/DVI SuperSign
To Next Page
Loading...
Need help?
General
